We all know that plastic woven bags have a certain degree of permeability. If they are used to hold products that need to be stored in a completely dry environment, a layer of plastic film needs to be attached to the surface of the woven bag to achieve the purpose of moisture prevention. Such woven bags are also called coated woven bags. The most common ones are the cement packaging bags that we often come across. We not only need to ensure that the cement is smoothly filled during the filling process under the action of a certain wind pressure, but also need to ensure that the cement remains dry during transportation, loading and unloading, and storage. Coated plastic woven bags, like other packaging bags, in addition to meeting the basic functions of packaging cement, also need to solve the problems of exhaust during filling, temperature resistance, and moisture prevention. And by punching holes in the coated plastic woven bag, this is the key to solving these technical problems.
Most cement enterprises adopt the gas transportation method for cement filling during the filling process. If the exhaust problem cannot be well solved during the filling process, it will not only affect the filling efficiency, but also reduce the qualified rate of bag weight, leading to non-compliance with product quality standards. For the laminated plastic woven bags used to hold cement, the running, leaking and spilling of cement during filling and the moisture-proof phenomenon must be comprehensively considered. If the exhaust holes are large and numerous, the exhaust performance is good and the filling efficiency is high, but the running and spilling of cement during filling are serious and the moisture-proof performance is poor; if the exhaust holes are small and few, the exhaust performance is poor, the filling efficiency is low, but the running and spilling of cement are less and the moisture-proof performance is good. Therefore, the size and density of the needle holes in the woven bag are the key factors affecting the running and spilling of cement during filling and the moisture-proof performance of cement. The diameter of the needle is 2mm or 1.5mm, which can meet the requirements of both aspects. The general operation is: there is one needle hole every 6mm along the longitudinal direction of the laminated fabric and one needle hole every 8mm along the transverse direction. The punching needle adopts a conical needle, and the exhaust holes are made by punching from the inside out. After processing with such laminated plastic woven bags, the gas can easily be discharged from the inside out during filling, meeting the exhaust requirements during cement filling and ensuring the qualified rate of bag weight. At the same time, the running and spilling of cement during filling is also solved. Because the cement production process and equipment level are different, the temperature of cement when it leaves the warehouse is also different, generally ranging from 50 ℃ to 100 ℃. If the base fabric of the laminated plastic woven bag can meet the requirements of the GB8974 national standard, it can completely solve the temperature resistance problem of cement packaging. If the temperature of cement when it leaves the warehouse is relatively high, we can appropriately increase the thickness of the laminated plastic woven bag. We must not blindly pursue cost reduction and use inferior plastic raw materials, add excessive additives, have unstable process conditions, and equipment level that does not meet the product quality requirements. Even if the plastic woven bag is very thick, it cannot fundamentally solve the temperature resistance problem.
